Solar Power Lights » DIY

Solar living room & kitchen LED lighting.

admin — Mon, 06 Feb 2012 08:47:24 +0000

Wiring setup of my LED lighting. I used 12/3 wire to bring power from my 12 volt battery bank to power up the LED lights. I used 3x one watt, 2x five watts for lighting in the living room and one watt and ten watts for the kitchen.

Duration : 0:12:6

Technorati Tags: 12 volt wiring, Battery, DIY, free electricity, free energy, Free power, grid tie inverter, harbor frieght, inverter, LED, led lamp, light, Light-emitting Diode, lights, low voltage, MPPT, outback charge controller, solar energy, solar led

Perpetual motion

admin — Sun, 29 Jan 2012 21:03:07 +0000

It’s like a magnet, it works but no one seems to really know how.
This is the closest you’ll come to seeing perpetual motion on You Tube, a Crookes Radiometer will function in very low light where a solar panel will struggle to find energy. The really confusing thing is, how do they get the gubbins inside this sealed glass bowl?

Duration : 0:1:29

Technorati Tags: ALTERNATIVE, Build, clean, climate, Crookes, Crookes Radiometer, DIY, electric, Electric Power Industry, electricity, energy, environment, free energy, Free power, Gas, generator, global, Global Warming, green, heat, IR, LED, led lamp, light, Light Mill, Light-emitting Diode, lights, magnet, Perpetual Motion, SOLAR, solar energy, solar power, Tesla, vacuum, warming, wind

Flexible Solar Panel 230 watts to a Grid Tie Inverter Wiring

admin — Thu, 19 Jan 2012 01:18:02 +0000

http://greenpowerscience.com/SOLARPANEL124.php
These are the 124 watt rollable solar panels tied in parallel to produce 230 watts of grid supplemented power. The panels are rated at 124 watts but the inverter uses a bit of power. This inverter is rated at 600 watts.

http://www.youtube.com/watch?v=hANi5NbcY5g

http://www.youtube.com/watch?v=J3b_fGUnaFE

Duration : 0:1:22

Technorati Tags: change, DIY, energy, evergreen, FREE, global, green, GREENPOWERSCIENCE, installation, panel, photovoltaic, photovoltaics, POWER, pv, SCIENCE, SOLAR, warming

Part one, Battery bank/outback charge controller cable upgrade and solar panel roof installation.

admin — Thu, 12 Jan 2012 04:43:19 +0000

Part one of Installed/upgraded zero gauge cables on the battery banks and 04 gauge on the outback mppt controller. Also how I made custome brackets for the solar panels installation on the roof.
Regards, Raz

Duration : 0:5:18

Technorati Tags: 10, ALTERNATIVE, Battery, Build, change, cheap, clean, climate, DIY, earth, easy, electric, electricity, energy, FREE, Gas, generator, green, grid, home, howto, hydrogen, LED, LED lighting, light, lights, LOW, magnet, magnetic, MPPT, off, panel, panels, photovoltaic, photovoltaics, POWER, renewable, simple, SOLAR, solar energy, SUN, System, Technology, Tesla, voltage, watt, wind

A Solar Powered Toy Car (Handmade)

admin — Sun, 08 Jan 2012 11:44:04 +0000

A Solar Powered Toy Car (handmade),
This could be cheaper and interesting,
educational too. see how strong is sunshine power.
————————————————

Tip from samimy:

search google for (Elekit)

the water bottle size doesn’t matter, even the big bottle
of water you see in the market (2 litters) they work, because
it is light, not heavy.

so size of the bottle doesn’t matter.
weight: make sure it is empty.

and the solar board size, you should choose the size based on your
motor.
see if your motor needs 2 volts, you should use a 2 volt solar panel,
or if your motor is 3 volt, do the same, find a 3 volt out put solar panel.
the physical size doesn’t matter, little big or small, it is okay.

use tires as much as lighter, not heavy is better.

thanks

visit my channel for more projects from Samimy:

www.youtube.com/samimys

samimy

Duration : 0:2:36

Technorati Tags: BOTTLE, Cars, DIY, electronics, energy, handmade, how-to-make-solar-car, POWER, recycling-bottles, samimy-production, samimys, simple, SOLAR, SUN, sunshine, Toys

THE SOLAR PHOTOVOLTAIC $1 a watt DIY Solar Panel Part 2 Make your own solar panel series Bus Wire

admin — Wed, 28 Dec 2011 21:54:03 +0000

This is part 2 and covers the basics for beginners + The cells I am using are all broken cells I purchased for a discount from Ebay. They were all fully pre-tabbed cells. They are the long tab or fully tabbed NOT the clipped tabs. This panel will cost about $60 completed and requires about 1-3 hours of work + resin embedding cure times which are best applied overnight. Part 3 will detail the embedding process and adding an optional blocking diode. How To Build A Solar Panel.

Part 1 :

http://www.youtube.com/watch?v=hNH2YGzwznI

DIY solder foil:

http://www.youtube.com/watch?v=0znN-3SY7jQ

Duration : 0:12:57

Technorati Tags: BUS, cells, CONNECTION, DIY, energy, GREENPOWERSCIENCE, GREENPOWERSCIENCE.COM, panel, photovoltaic, POWER, pv, SERIES, SOLAR, TABBING, WIRE

DIY – Home Solar Power Part #3

admin — Sun, 25 Dec 2011 14:41:33 +0000

I’ve updated my system with 2 more batteries that will give me 440 amp hours, added some wood planks for more support on my shelf, a 60 amp breaker, and some small emergency lighting. Overall I believe this system will support my needs for a true emergency backup system providing hours of emergency power.

Duration : 0:4:28

Technorati Tags: AGM, ALTERNATIVE, Backup, Battery, DIY, energy, FREE, generator, inverter, Kyocera, panels, POWER, renewable, rhandsom, SHTF, SOLAR, switch, transfer, trimetric

Homemade Solar Charger | Useful Diy Project

admin — Thu, 22 Dec 2011 02:46:30 +0000

Below you’ll find a list of the components needed to make your own Solar Powered Charger. And If you enjoy my videos, please subscribe, comment/rate, etc. Thank you 

Solar Garden Lights – http://useth.at/au22u

USB Cable. Find one that is a cheap because you’ll have to cut it – http://bit.ly/cheap-usb-cable

IDE ATA Cable – http://useth.at/aamw5

Baseball Card Sleeves – http://useth.at/a5lck

Colored Electrical Tape – http://useth.at/a4ufc

Voltmeter, Multimeter – http://useth.at/a4ufc
Soldering Iron. You won’t need an expensive one for this project. – http://bit.ly/soldering-iron

Scissors or wire cutters. My favorite tool for this kind of task is the 5-in-1Multi-Purpose Scissors right here – http://bit.ly/t3ERkQ

Solar electricity garden lighting unit were a great idea that just haven’t proved helpful. Allow me to explain you how to transform these garden lamps into something truly useful.

how-to solar energy battery power charger portable folding cells electricity panels photovoltaic power lights lamps
how
to
diy
“how to diy”
“do it yourself”
“home diy”
homemade
gadget
electronics
tech
the
science
amazing
interesting

Duration : 0:4:56

Technorati Tags: Amazing, Battery, cells, charger, DIY, do it yourself, electricity, electronics, energy, folding, gadget, home diy, homemade, HOW, how to, how to diy, interesting, Lamps, lights, panels, photovoltaic, portable, POWER, SCIENCE, SOLAR, tech, Technology, the, TO

☆ ☆ ☆AMAZING DIY SOLAR SHED LIGHTING☆ ☆ ☆

admin — Fri, 02 Dec 2011 01:51:16 +0000

Amazing solar shed lighting. This was a small Diy Project I did because I had no power running to my shed.
I used an old car battery and attached this to a small 12v 1.5watt solar pannel attached to my shed. I then purchased a small 3w 12v led lightbulb that was made for boats and similar. I wired it all up and now I have an amazing bright solar shed light. I was really pleased as this has made my shed much more usable. Enjoy and plese sub if you can. :0)

Duration : 0:1:42

Technorati Tags: Amazing, amazing diy, change, climate, DIY, diy led, diy project, Diy solar light, diy solar project, free energy, Free power, free stuff, global, green energy, how to, LED lighting, Light-emitting Diode, LIGHTING, lights, Power (physics), Random, shed, SOLAR, solar project, solar shed light, Superb, totally free, wd40 tricks

Outside the house solar powered 12 volt LED lights controlled with a light sensor kit.

admin — Mon, 28 Nov 2011 14:50:08 +0000

My outside lights using a Velleman MK125 light sensor kit. I used 18/3 AWG wire to bring electricity from my battery banks to the front of the house. I used two positives and a common negative (both switched) to power the sensor and the lights in front of the house. The lights come on at dusk and go off at down with an adjustable sensitivity control knob. I also terminated my Malibu lights low voltage transformer and connected them to the sensor, I also replaced the Malibu light bulbs with LEDS.

Duration : 0:8:9

Technorati Tags: 12 volt light led, ammo, automatic lightinc, DIY, energy, free electricity, free energy, free light, grid tie inverter, harbor freight, inverter, Kits, led lamp, light fixture, light sensor, Light-emitting Diode, Lights Led, low voltage led lights, magnet, malibu led lights, malibu lights, off grid, outback, prepping, SHTF, shtf survival, SOLAR, solar energy, Solar panel, solar-powered, survival, Survival Gear, tesla coli, velleman